Mortorcycle Quetions |
| does
not start, though makes a clicking sound |
| battery
connections. If they look like their is a white power on them |
| sand
them. If it still does not work you might need a battery or really |
| it
could be wiring problems or check to see if their is a fuse. |
| does
not start at all = you the above answer then and you might |
| need
a start. The starter has 2 wires that if you attach the wire, careful |
| one
is always on, the car will start if the starter is could. |
| shut
off after running a little bit = check your starter wires. |
| You
might need a new starter. The starter charges the battery with |
| electricity. |
| makes
a high pitch sound when I stop=Your break pads could |
| be
bad and if you keep stopping with the car the rotors might go. View |
|
the front brakes go far down to view how to change them |
| makes
a low loud sound when running=you have a hole in the |
| muffler
or exist manifold. |
| reer
brakes go to far down= you might need to adjust the brake. |
| On
the reer while thier should be an adjuster on some mortorcycles. |
| Just
tighten it. Press the brake down to find it. It will move. |
| Front
brakes go to far down= you might need to bleed the brake. |
| Their
is the brake fluid box on the terning bar that will require more fluid |
| and
when taking off the breaks. Open the drain plug and fluid will flow out. |
| A
tube must be attached to the drain break plug. Pump the brakes till all |
|
the air comes out. Then screw it tight while their is no air. Rare though you
|
| might
need hoses or the brake fluid holder is cracked. |
| does
not brake at all=Front and reer breaks go down far category. |
| rear
break light does not work= Their is a screw in the reer side |
| of
the bike that can be tigthen to work. Press the break down to find it. |
| I
saw a rip on the tire seal when someone put it on=This can |
| create
a tiny air leak or a bid on a crime. Make sure their is no ripe. |
| If
you fall off the bike you can be seriousley hurt. |
| How
do I take the tire off= You take the pin out of the nut, unscrew |
| then
nut and pul the large pin out. You can place a small pipe |
| on
it and hit it to take the larege pin out. |
More
sAnswers Coming Soon! |
| |
